General features and advantages of the Mezzanine
Floor Lifter:
Design, manufacture and install 1 off
mast-type goods lift to be installed alongside a mezzanine
floor system for Aston
Martin Lagonda Limited
The lift will be constructed using a
single mast which must be bolted down to the ground floor
as well as the block work wall to the left of the mezzanine.
Brackets will be supplied to support the mast rigidly
away from the structural building brace.
(Dimensions to be confirmed during pre-manufacture
site survey)
The lift platform will measure approximately
2200mm wide by 1600mm deep and will close down over
the legs
The clear working platform area will
be 2140mm x 1540mm
The overall plan size of the lift will
be approx 2200mm wide x 1850mm deep The platform
will feature 1100mm high rails on all sides with twin outwards opening gates
opposite the mast (Side B) and to the left of the mast (Side A)
The gates will lock with a gravity system but will
also be sensed to prevent platform movement if the gate is
open.
The platform will close to the floor
with a 60mm lowered height and have a total raised height
of 3460mm
The maximum lift height will be governed
by a limit switch system to ensure that the platform
parks with the mezzanine upper floor.
The platform will be supplied with a
loading ramp to be permanently fixed to the ground floor
measuring 2200mm wide by 600mm long giving a gradient
of 10%. Mounted opposite the mast (Side B)
The hydraulic power pack will be mounted
to the mast and electrical system will be housed in a
separate box, mounted on the enclosure at ground level.
Control points will be positioned at
both ground and upper floor levels. Both points will
feature latching call buttons and emergency stop controls.
Power requirement: 415V 3 phase + Neutral via 10amp isolator
(Supplied by customer install location
TBC)
Motor specification: 0.8Kw 3phase 415V
with 4ltr reservoir
Maximum lift capacity will be
200Kg
Manufacture and install 1 off External
guard system for both upper and lower floors
The lift will be supplied with an external
guard to fully enclose the unit and will comprise as
follows:
5660mm high mesh panels on 3 exposed
sides incorporating twin outward opening gates 2000mm
high opposite the mast (Side B) at ground level and
twin outward opening gates 2000mm high to the left of the
mast (Side A). The gates will be fitted with an electrical
interlock to prevent opening when the lift is not parked.
The enclosure will reach under the mezzanine
at ground level by 200mm with panels 2500mm high. At
mezzanine level the enclosure height will be 2200mm again
reaching in 200mm. This is to allow appropriate clearance
between the outside face of the enclosure and the moving
lift car
Overall size of enclosure 2600mm x 2050mm
Installation:
Installation of the lift at: Aston
Martin Lagonda Limited,
Banbury Road,
Gaydon,
Warwick.
CV35 ODB
We estimate that this installation
will take two installers, a maximum of 4 days for completion.
Delivery:
The unit will be delivered the day before installation
is scheduled.
|
